MakePk
繁中简中EN日本語한국어
‹ Back to home

Packaging size converter

Inner, die-face and outer sizes differ by one board caliper; this page converts between all three and shows millimetres and inches at once.

Enter sizes

mm
mm
mm
mm

Typical 0.3–5 mm

How to read sizes

Units

All three sizes

Top line is millimetres (the formula unit). Bottom line is inches.
Size Length L Width W Height H
InnerEntered
Die face
Outer

Inner L = die-face L − 4T, W − 2T, H − 2T. Outer L = die-face L + T, W + 2T, H + T.

Inner, die-face and outer sizes differ by one board caliper; this page converts between all three and shows millimetres and inches at once.

How the three sizes relate

The inner size is the clear cavity, the die-face is crease to crease, and the outer is the outside of the box. For single-wall board, die-face = inner + 2T and outer = die-face + 2T.

Which one to use

Use the inner size for the product, the die-face for the die maker, and the outer for packing and freight. Switch modes on this page and the numbers follow.

Common questions

Why is the die-face 2T larger than the inner?
The crease sits at the middle of the board, so each wall takes one caliper; the two sides add up to 2T.
Which boxes does this conversion fit?
This uses the double-wall mailer stack. Tuck cartons and RSC boxes are single-wall tubes; use their own size panels.