Enter depth, width, height and caliper to draw a reverse-tuck net; switch between inner, die-face and outer, then export SVG, PDF or DXF.
L is the side panel (front-to-back depth), W is the face width, and H is the height. Inner, die-face, and outer sizes use a single-wall tube, not the mailer double-wall formula. Die face is crease to crease.
Folding cartons are often 0.3–1.2 mm. This page allows 0.2–5 mm.
Stop anywhere between flat and shut. Preview only — the die file does not change.
Inner L and W = die-face − 2T; inner H matches the die face. Outer L and W match the die face; outer H = die-face H + 2T. All three match when T = 0.
Reverse tuck: the top lid and tongue are on the front, the bottom lid and tongue on the back, with a crease between lid and tongue. Dust flaps sit on both sides, with a rounded tip, steep sides, and a short angled return to the hinge. The glue flap is on the left of the front, tapered at both ends, about 12–15 mm, adjusted with caliper.
The window is centred and stays 4 mm from any crease; it is a cut line, so SVG, PDF and DXF all include it. The 3D preview does not show it yet.
One-piece reverse-tuck carton. Left to right: glue flap, front W, side L, back W, side L. The top lid hinges on the front and the bottom lid on the back. Lid depth is about the side panel, and a shorter tongue continues past the lid with its own crease. Dust flaps hinge on the side panels: rounded tip, steep sides, and a short angled return to the hinge, stopping short of the opening center. The glue flap tapers at both ends. Clearances are in caliper T. The 3D tab folds the net; cut from the flat die. Units are mm. Check sizes before you cut.
MakePk free packaging tools — more coming
Die face
—
Inner
—
Approx. outer
—
Drag to turn · scroll to zoom
The spine runs glue flap, front W, side L, back W, side L. The top lid and tongue hinge on the front and the bottom lid on the back, with dust flaps on both side panels, so the two tongues enter the tube from opposite faces.
The L and W panels are outside dimensions, so inner = panel − 2T; the H panel is the inner height. Switching modes converts through the caliper automatically.
Folding cartons usually use 0.3–1.2 mm board. The tongue is about a quarter of the depth and is capped by the wall height, so thicker board shortens it slightly to avoid jamming.
| Size (mm) | Caliper | Load |
|---|---|---|
| 60 × 90 × 150 | 0.5 mm | Load |
| 80 × 50 × 40 | 0.5 mm | Load |
| 100 × 70 × 30 | 0.35 mm | Load |