MakePk
繁中简中EN日本語한국어

Sleeve dieline generator

A sleeve is a paper tube that slides over a box. Enter the box size and caliper to see the flat die and the sleeve opening.

‹ Back to home

Box size

Enter the box the sleeve wraps (inner size) and the caliper; the sleeve opening adds the board and a 0.5 mm clearance.

mm
mm
mm

Board thickness T

Sleeves use 0.3–2 mm board; too thin feels floppy, too thick will not slide on.

How to read sizes

Bleed Cut Crease

Die face
—

Inner
—

Approx. outer
—

Drag to pan · scroll to zoom

What a sleeve is

A sleeve is a lidless tube that slides over a box and holds it shut. Book sleeves, gift box wraps and card boxes all use one.

How the sizes work

Panel width = box width + 2T + 0.5 mm clearance; panel height = box height + 2T + 0.5; the sleeve height equals the box depth.

Caliper and fit

Caliper changes both the opening and the stiffness. Half a millimetre is noticeable, so re-check when you switch board.

Common sizes (one click to load)

Size (mm)CaliperLoad
150 × 100 × 600.5 mmLoad
200 × 140 × 800.5 mmLoad
100 × 70 × 300.35 mmLoad

Common questions

How much clearance should a sleeve have?
0.5 mm by default; go to 1 mm if the board is laminated or uneven.
Is there a 3D preview?
No. A sleeve is an open tube, so the flat die is enough to check.