MakePk
繁中简中EN日本語한국어

Envelope dieline generator

Side-seam wallet envelopes: set the body size, side glue tabs and seal flap, then preview and export SVG, PDF or DXF.

‹ Back to home

Envelope and flap dimensions

W × H is the crease-to-crease body size, not usable inner space. Contents must be smaller; check a paper sample. Units: mm.

mm
mm
mm
mm

Envelope presets

Bleed Cut Crease

Flat size (without bleed)
—

Body W × H
—

Seal overlap
—

Drag to pan · scroll to zoom

Envelope or sleeve?

An envelope has a body, side glue tabs, back and sealing flap. After three edges are assembled, contents enter through the top mouth. A sleeve is a tube open at both ends; the dielines are not interchangeable.

How are the dimensions calculated?

DL defaults to 220 × 110 mm; C6 is 162 × 114, C5 229 × 162, C4 324 × 229. Flat width is W+2S, flat height F+2H−5. The back ends 5 mm below the mouth and the seal overlaps by F−5 mm. This panel model does not compensate for paper or contents thickness.

Sample and export checks

Make an unprinted sample to check fit, side seams and a sealing flap that does not stick to the contents. Open exports in mm at 100% scale and inspect cut, crease and 3 mm bleed separately. Confirm postal size and paper with the carrier and converter.

Common questions

Are W and H inner dimensions?
No. W × H is the nominal crease-to-crease body size. Adhesive, paper thickness and folds affect usable space; allow clearance and make a sample.
Are windows, 3D or gussets supported?
This is a flat wallet envelope without windows, gussets, release liners, adhesive tape positioning or 3D folding. SVG, PDF and DXF exports are available.