Both nets are generated together: the lid grows by c per side and its wall is shorter, so it slips over the base without slack.
L is the longer horizontal side, W the shorter, and H the usable inner height of the base. The base is a bottom panel with four walls; the lid slips over the outside. Inner, die-face, and outer follow one board caliper; die-face means crease to crease.
Folding cartons are commonly 0.3–1.2 mm; this page allows 0.2–5 mm.
Base: inner L, W, H equal the die-face. Outer L = die-face L + 2T, W = die-face W + 2T, H = die-face H + T. The lid has no second form field; its panel is the base outer plus a per-side clearance.
Both the base and the lid are a bottom (or top) panel with four walls. The left and right walls each carry two glue tabs that fold inward onto the front and back walls. The lid panel is slightly larger and its walls are about 0.7H for a partial telescope.
Lid panel = base outer + 2c (per side c = clamp(T + 0.6, 0.8, 3.0) mm); wall height = clamp(0.7H, 12, H).
—
The window is centred and stays 4 mm from any crease; it is a cut line, so SVG, PDF and DXF all include it. The 3D preview does not show it yet.
A lid-and-base box is a two-piece telescoping set: the base is a shallow tray, and the slightly larger lid slips over it. Both are a bottom (or top) panel with four walls. The left and right walls carry two glue tabs each; they fold inward and glue to the front and back walls. The lid panel is larger than the base outer by c per side, where c = clamp(T + 0.6, 0.8, 3.0) mm. The lid wall height = clamp(0.7 × H, 12, H). The base inner and die-face are equal because the walls fold outside the bottom panel; the outer envelope adds T per side and T in height. This page is a flat die only: no 3D fold preview, but DXF exports (R12, mm, three layers). Units are mm. Check the dimensions before cutting.
MakePk free packaging tools — more coming
Base · die-face
—
Base · inner
—
Base · outer
—
Lid · panel
—
The base is a shallow tray with glue tabs folded inward. The lid is a slightly larger tray with a shorter wall that drops over the base. The two pieces are printed and glued separately.
c = clamp(T + 0.6, 0.8, 3.0) mm per side; the lid wall is clamp(0.7×H, 12, H). Thicker board needs a larger c.
Gift, confectionery and cosmetics boxes use 1.0–2.0 mm grey board or thick card. Stiffness comes from the board and fit from c; start from the defaults and adjust.
| Size (mm) | Caliper | Load |
|---|---|---|
| 150 × 100 × 50 | 1 mm | Load |
| 200 × 150 × 60 | 1.5 mm | Load |
| 100 × 100 × 40 | 1 mm | Load |