Enter the inner size and board caliper to draw a standard RSC net, with major flaps, minor flaps, glue flap and root reliefs.
L is the length (the deeper face), W is the width (the shorter face), and H is the wall height. The L panels are outside and the W panels sit between them; inner, die-face, and outer sizes use a single-wall tube. The default is an inner 300 × 200 × 150 mm corrugated box with T = 3 mm.
Corrugated board is often 2–4 mm. This page allows 0.2–10 mm.
Inner L = die-face L − 2T; W and H match the die face. Outer L = die-face L, W = die-face W + 2T, H = die-face H + 2T. All three match when T = 0.
RSC / FEFCO 0201: left to right, glue flap, L, W, L, W. Four flaps at each end. The L panels carry the major flaps, about half the clear width deep, meeting near the centre. The W panels carry the shorter minor flaps, leaving a centre gap. Each flap root has a relief slit. The glue flap is on the left L panel, 30–40 mm wide with tapered ends.
The window is centred and stays 4 mm from any crease; it is a cut line, so SVG, PDF and DXF all include it. The 3D preview does not show it yet.
One-piece Regular Slotted Container. Left to right: glue flap, L, W, L, W. L is the length, W the width, and H the wall height. Each end has four flaps: the major flaps on the L panels are about half the clear width deep and meet near the centre; the minor flaps on the W panels are shorter and leave a centre gap. A small root relief separates neighbouring flaps and gives the folds room. The glue flap is on the left L panel, 30–40 mm wide with tapered ends. Sizes can be inner, die-face, or outer; caliper T converts all three. This is a flat die; a folding preview is not available yet. Cut from the flat die. Units are mm. Check sizes before you cut.
MakePk free packaging tools — more coming
Die face
—
Inner
—
Approx. outer
—
RSC is the Regular Slotted Container, the common slotted shipper: four body panels and two major plus two minor flaps at each end. The major flaps meet at the centre line.
Corrugated board is usually 3 mm (B flute) or 5 mm (BC flute). This page converts inner and outer sizes through a single caliper, so raise T for thicker board and check the result.
Add 5–10 mm to the product for loading and cushioning. Minor flaps run about 90% of the major depth, leaving a centre gap for the tape line.
| Size (mm) | Caliper | Load |
|---|---|---|
| 300 × 200 × 150 | 3 mm | Load |
| 400 × 300 × 200 | 5 mm | Load |
| 200 × 150 × 100 | 3 mm | Load |