Both lids hinge on the same front panel and both tongues fold into the same tube; set the size and caliper to preview and export.
L is the side panel (front-to-back depth), W is the face width, and H is the height. Inner, die-face, and outer sizes use the same single-wall tube as the tuck page, not the mailer double-wall formula. Die face is crease to crease.
Folding cartons are often 0.3–1.2 mm. This page allows 0.2–5 mm.
Stop anywhere between flat and shut. Preview only — the die file does not change.
Inner L and W = die-face − 2T; inner H matches the die face. Outer L and W match the die face; outer H = die-face H + 2T. All three match when T = 0.
Straight tuck (STE): both the top and bottom lids hinge on the front, and both tongues fold into the same tube from that face. The back edges are plain, with no opposite tongue. Dust flaps sit on both side panels at the top and bottom. The glue flap is on the left of the front, tapered at both ends, about 12–15 mm.
The window is centred and stays 4 mm from any crease; it is a cut line, so SVG, PDF and DXF all include it. The 3D preview does not show it yet.
One-piece straight tuck end carton. Left to right: glue flap, front W, side L, back W, side L. Both the top and bottom lids hinge on the front panel, each with its own tongue, and both tongues fold into the same tube. The back top and bottom edges are plain. Dust flaps hinge on both side panels at each end, with rounded outer corners and steep sides. The glue flap is on the left of the front, tapered at both ends. Caliper T drives the inner, die-face, and outer sizes. This page is a flat die: the 3D tab folds the net, and DXF exports too. Units are mm. Check sizes before you cut.
MakePk free packaging tools — more coming
Die face
—
Inner
—
Approx. outer
—
Drag to turn · scroll to zoom
A reverse tuck puts the top lid on the front and the bottom lid on the back. A straight tuck puts both on the front and leaves the back edges plain; card and game boxes use it because they open from one face and stack without pressing the other lid.
L is the front-to-back depth and W the face width. The tongue is about a quarter of the depth, capped by the height; dust flaps sit on the sides and the back stays plain.
Card and board game boxes use 0.4–0.8 mm white or grey board. At 40–70 mm depth the tongue lands around 12–18 mm, which is enough grip.
| Size (mm) | Caliper | Load |
|---|---|---|
| 63 × 88 × 30 | 0.4 mm | Load |
| 100 × 100 × 60 | 0.6 mm | Load |
| 130 × 130 × 80 | 0.6 mm | Load |